G4 Mobile Recorder• Installation Guide and Platform Settings
22
Demo Mode: You can turn it on/off. When the mode is on, the alarm interval shortens, which
is suitable for demonstration.
Delay Time of Shutdown: You can set the delay time of device shutdown after turning off the
vehicle.
License Plate Number: You can set the license plate number of the vehicle.
G-Sensor Emergency Recording: You can turn it on/off. Emergency recording will be enabled
when the gravity sensor is triggered (such as sudden acceleration, sudden deceleration, and
vibration).
G-Sensor Sensitivity: You can set the sensitivity as high, medium, and low. The higher the
sensitivity is, the more easily the G-Sensor emergency recording will be triggered.
Parking Monitoring: After the function is enabled, if the G-Sensor is triggered, the device will
be woken up, record for one minute, and go to the low power sleep status.
Overspeed Alarm: You can set the max. vehicle speed. When the speed exceeds the set value,
the device notices with an audio prompt: You are about to exceed the speed limit. If you
connect the device to a platform, the alarm will be reported to the platform. You can also edit
this parameter remotely via 808 Protocol.
Overspeed Sensitivity: You can set the sensitivity to trigger the overspeed alarm. The higher
the sensitivity is, the more easily the alarm will be triggered.
Network Parameters
Go to Settings > Network Parameters.
Set Network Parameters
Wi-Fi Settings: You can set the SSID and password of the device wireless AP hotspot.
Cellular Data: You can enable/disable the cellular data.
4G Network Settings: You can enable/disable and set the APN information of private network
and check the signal status.
