65
Figure 65 Record Schedule Configuration Menu
3.
Select the camera to configure from the camera dropdown list.
4.
Check the Enable Schedule checkbox to enable the record schedule. If the checkbox is
unchecked, the record schedule will be disabled.
5.
Edit the record schedule. There are three ways to set the record schedule:
Instant edit
1) On the Record menu, select a day from Monday to Sunday to configure schedule for.
2) Setup time periods for schedule. If the 24HR checkbox is checked, recording will
occur over the entire day. To setup multiple time periods, uncheck 24HR and enter
the Start/End Time for the selected day. The start/End time are listed using a 24 hr
cycle (i.e. 18:00 is equivalent to 6:00pm). Up to 8 discontinuous periods can be
configured for each day.
3) Select recording type under Type for selected day of the week. Recording type
includes Continuous for continuous recording or Event when an event is triggered
(i.e., from detected motion) for the selected time period.
4) Select the Add button to add time frame to schedule. The newly added time frame
will appear in the schedule on the right. You can click
to delete the selected time
period on the right. Continuous recordings are shown in blue on the schedule while
Event recordings are shown in yellow. An example of this can be seen in Figure 66.
Summary of Contents for DS-7200HGHI-SH Series
