UM DS-90xxHUHI-F8/N User Manual 041717NA
12
2.
IR Remote Control Operations
The DVR may also be controlled with the included IR remote control. The keys on the remote control closely
resemble the ones found on the front panel.
NOTE:
Batteries (2 × AAA) must be installed before operation.
Table 1.1
, Description of the IR Remote Control Buttons
No. Name
Description
1
POWER
Power on/off the device
Power on/off the device by pressing and holding button 5 seconds
2
MENU Button
Press the button to return to the main menu after successful login
Press and hold button for 5 seconds to turn off audible key beep
In PTZ Control mode, MENU button will start wiper (if applicable)
In Playback mode, shows/hides the control interface
3
REC Button
Enters Manual Record setting menu
In PTZ control settings, press button and then call a PTZ preset by
pressing numeric button
Also used to turn audio on/off in Playback mode
4
DIRECTION
Button
Navigate between different fields and items in menus
In Playback mode, the Up and Down buttons are speed up and
slow down recorded video. Left and Right buttons will select the
next and previous record files.
In Live View mode, buttons cycle through channels
In PTZ control mode, controls movement of the PTZ camera
ENTER
Button
Confirms selection in any of the menu modes
Can also be used to
tick
checkbox fields.
In Playback mode, plays or pauses the video
In single-frame Playback mode, advance video a single frame
5
PTZ Button
In Auto-switch mode, stops/starts auto switch
6
DEV
Enables/Disables Remote Control
7
Alphanumeric
Buttons
Switches to corresponding channel in Live View or PTZ Control
mode
Inputs numbers and characters in Edit mode
Switches between channels in the Playback mode
8
ESC Button
Goes back to the previous menu
Press to Arm/disarm the device in Live View mode
9
PLAY Button
Enters All-day Playback mode
Also auto scans in the PTZ Control menu
10
PREV Button
Switches between single screen and multi-screen modes
In PTZ Control mode, adjusts the focus in conjunction with the
A/FOCUS+ button
2.1.
Troubleshooting the Remote Control
NOTE:
Make sure batteries have been installed properly in the remote control.
Also note that the remote control must be aimed at the IR sensor on
the DVR front panel.
If there is no response after you press any button on the remote, follow the procedure below to
troubleshoot:
1.
Go into Menu > Configuration > General > More Settings by using the front control panel or the mouse.