9.4.2 Configure Basic Information
You can add person to the client one by one and configure the person's basic information such as
name, email, phone number, etc.
Steps
1. Enter Person module.
Note
For the first time you enter Person module, a window pops up, and you can set the rules to
generate person ID (letters and numbers supported) when adding person. When getting person
information from device, if there are no person IDs, the person IDs will be generated according
to the rule.
2. Select an organization in the organization list to add the person.
3. Click Add to open the adding person window.
The Person ID will be generated automatically.
4. Enter the basic information including person name, telephone number, email address, validity
period, etc.
5. Confirm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and continue to add other persons.
9.4.3 Issue a Card by Local Mode
If a card enrollment station is available, you can issue a card by local mode. To read the card
number, you should connect the card enrollment station to the PC running the client by USB
interface or COM, and place the card on the card enrollment station.
Steps
1. Enter Person module.
2. Select an organization in the organization list to add the person and click Add to enter Add
Person panel.
Note
Enter the person's basic information first. For details about configuring person's basic
information, refer to Configure Basic Information .
3. In the Credential → Card area, click +.
4. Click Settings to enter the Settings page.
5. Select Local as the card issuing mode.
Face Recognition Terminal User Manual
109
