The alarm can be triggered if the door has not been closed in a configured time period. If it is
set as 0, no alarm will be triggered.
Duress Code
The door can open by inputting the duress code when there is duress. At the same time, the
client can report the duress event.
Super Password
The specific person can open the door by inputting the super password.
Note
●
The duress code and the super code should be different.
●
The duress code and the super password should be different from the authentication
password.
●
The length of duress code and the super password is according the device, usually it should
contains 4 to 8 digits.
5. Click OK.
6. Optional: Click Copy to , and then select the door to copy the parameters in the page to the
selected doors.
Note
The door's status duration settings will be copied to the selected door(s) as well.
Configure Parameters for Card Reader
After adding the access control device, you can configure its card reader parameters.
Steps
1. Click Access Control → Advanced Function → Device Parameter .
2. In the device list on the left, click to expand the door, select a card reader and you can edit the
card reader's parameters on the right.
3. Edit the card reader basic parameters in the Basic Information page.
Note
●
The displayed parameters may vary for different access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Information page, click Advanced
to edit the parameters.
Basic Information
Name
Edit the card reader name as desired.
Minimum Card Swiping Interval
Face Recognition Terminal User Manual
132
