1) Select an organization in the organization list to add the person and click Add.
Note
Enter the person's basic information first. For details about configuring person's basic
information, refer to Configure Basic Information .
2) In the Custom Information panel, enter the person information.
3) Click Add to add the person and close the Add Person window, or click Add and New to add
the person and continue to add other persons.
9.4.11 Configure Resident Information
If the person is resident, for video intercom purpose, you need to set the room number for
her/him and bind an indoor station. After bound, you can call this person by calling the indoor
station and perform video intercom with her/him.
Steps
1. Enter Person module.
2. Select an organization in the organization list to add the person and click Add.
Note
Enter the person's basic information first. For details about configuring person's basic
information, refer to Configure Basic Information .
3. In the Resident Information panel, select the indoor station to bind it to the person.
Note
If you select Analog Indoor Station, the Door Station field will display and you are required to
select the door station to communicate with the analog indoor station.
4. Enter the floor No. and room No. of the person.
5. Confirm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and continue to add other persons.
9.4.12 Configure Additional Information
When adding person, you can configure the additional information for the person, such as person's
identity type, identity No., country, etc., according to actual needs.
Steps
1. Enter Person module.
2. Select an organization in the organization list to add the person and click Add.
Face Recognition Terminal User Manual
118
