4. Optional: Check Enable NTP and set the NTP server address, the NTP port, and the
synchronization interval.
5. Optional: Check Enable DST and set the DST start time, end time and the bias.
6. Click Save.
6.11.4 Set System Maintenance
You can reboot the device remotely, restore the device to default settings, etc.
Steps
1. Click Maintenance and Management → Device to enter the device list.
2. Click to enter the remote configuration page.
3. Click System → System Maintenance .
4. Maintain the device.
Reboot
The device starts rebooting.
Restore Default Settings
Restore the device settings to the default ones, excluding the IP address.
Restore All
Restore the device parameters to the default ones. The device should be activated after
restoring.
5. Remotely upgrade the device.
1) In the Remote Upgrade part, select an upgrade type.
Note
• You need to set the device ID before upgrading if you select Controller Upgrade File as the
remote upgrade type.
• Only the card reader that connected via RS-485 protocol supports upgrading.
2) Click ... to select an upgrade file.
3) Click Upgrade to start upgrading.
Note
Do not power off during the upgrading.
6.11.5 Manage Network User
Steps
1. Click Maintenance and Management → Device to enter the device list.
2. Click to enter the remote configuration page.
3. Click System → User → Network User .
4. Click Add to add the user.
DS-K3B501S Series Swing Barrier User Manual
87
Summary of Contents for DS-K3B501S Series
