Chapter 2 Wiring
2.1 Components Introduction
By default, basic components of the turnstile are connected well. The pedestals can communicate
by wiring the interconnecting cables. And the turnstile supports wiring the AC electric supply for
the whole system's power supply.
Note
The voltage fluctuation of the electric supply is between 100 VAC and 220 VAC, 50 to 60 Hz.
The picture displayed below describes each component's position on the turnstile.
Figure 2-1 Components Diagram 1
The picture displayed below describes the IR adapter and the IR sending/receiving board and their
corresponding number on the pedestal.
DS-K3B501S Series Swing Barrier User Manual
3
Summary of Contents for DS-K3B501S Series
