Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Product Support Team
12
Note:
The RS485 port 4 is for master face recognition terminal, port 6 for slave face recognition terminal.
If face recognition terminal is installed on both sides(IN&OUT both direction). Please configure port 4
and 6 from RS-485 drop-down list. Peripheral set as ID Card Identification Terminal, select Enter or Exit
direction according to site situation, Bitrate must be 115.2K.
3)
Power off the barrier and set No.1 dip switch as on, which means enable study mode. Adjust both
side swing to correct position manually. Then power on the barrier again and wait study process
finish(the barrier will open and close for one time).
4)
After device boot finish, then power off the barrier and set No.1 dip switch to 0(normal mode), and
restart the barrier to take effect.
3.2 Configure face recognition terminal
1)
Activate device and set activation password, long press the screen and it will prompt to input the
password, after that we can enter the menu；
2)
We have 4 methods to manage the data：
①
Register from device local：enter device menu User Management，select add user, input name
and card number, select face picture to enroll face，after enrolled successfully, click save；
