Chapter 4 General Wiring
4.1 Components Introduction
By default, basic components of the turnstile are connected well. The pedestals can communicate
by wiring the interconnecting cables. And the turnstile supports wiring the AC electric supply for
the whole system’s power supply.
Note
The voltage fluctuation of the electric supply is between 100 VAC and 220 VAC, 50 to 60 Hz.
The picture displayed below describes each component's position on the turnstile.
Note
The diagram is for reference only.
Figure 4-1 Components Diagram
The picture displayed below describes the IR sending/receiving module and their corresponding
number on the pedestal.
DS-K3B601SX Series Swing Barrier User Manual
10
Summary of Contents for DS-K3B601S Series
