2. Set the entrance and exit inductive mode as Single Triggered or Triggered Simultaneously.
3. Set custom IR detector mode.
Enable IR Emergency Mode
If some IR beams do not work properly, you can shield those IR beams to restore the lane. But
this action may hit person and cause injury.
Enable Custom Anti-pinch for Door Closing
Anti-pinch for door closing refers that the barrier will not close if the device has detected
person in the lane. Only after the person walks out of the lane, the barrier will close. If you
enable the function, you can shield parts of the IR beams for closing barrier in advance. But
this action may hit person and cause injury.
4. Click Save.
People Counting
Set people counting .
Steps
1. Click Configuration → Turnstile → People Counting to enter the page.
Figure 9-15 People Counting
2. Check to enable People Counting.
3. Enable Device Offline People Counting at your actual needs.
4. Select People Counting Type as Invalid, Passing Detection or Authentication Number.
5. Optional: Click clear to clear all the people counting information.
Set Light
Set the side light, barrier light and entrance light for the device.
DS-K3B631TX Series Swing Barrier User Manual
78
Summary of Contents for DS-K3B631TX Series
