8. Click Save to save the settings.
7.8.16 Set Image Parameters
Set the display settings, video standard, WDR, image adjustment, supplement light, and beauty.
Steps
1. Click Configuration → Image .
2. Configure the parameters to adjust the image.
Display Settings
Set the entrance or exit display.
Video Standard
Set the video frame rate when performing live view remotely. After changing the standard,
you should reboot the device to take effect.
PAL
25 frames per second. Suitable for mainland China, Hong Kong (China), the Middle East
countries, Europe countries, etc.
NTSC
30 frames per second. Suitable for the USA, Canada, Japan, Taiwan (China), Korea, the
Philippines, etc.
WDR
Enable or disable the WDR function.
When there are both very bright and very dark areas simultaneously in the view, WDR
balances the brightness level of the whole image and provide clear images with details.
Brightness/Contrast/Saturation/Sharpness
Drag the block or enter the value to adjust the live video's brightness, contrast, saturation,
and sharpness.
Supplement Light Parameters
Set the supplement light type from the drop down list and select to enable or disable it.
If you select On, you can set the light brightness.
If you select Disable, the function will be disabled.
Beauty
Set whiten and smooth value for the face appeared on the device live view page.
Start/end recording video.
Capture the image.
3. Click Default to restore the parameters to the default settings.
DS-K3B961TX Series Swing Barrier User Manual
56
Summary of Contents for DS-K3B961TX Series
