7.8.17 Event Linkage
Set linked actions for events.
Steps
1. Click Configuration → Event → Basic Event → Event Linkage to enter the page.
Figure 7-12 Event Linkage
2. Set event source.
-
If you choose Linkage Type as Event Linkage, you need to select event types from the drop-
down list.
-
If you choose Linkage Type as Card Linkage, you need to enter the card No. and select the
card reader.
-
If you choose Linkage Type as Employee ID Linkage, you need to enter the employee ID and
select the card reader.
3. Set linked action.
Linked Buzzer
Enable Linked Buzzer and select Start Buzzing or Stop Buzzing for the target event.
Linked Door
Enable Linked Door, check Door 1 or Door 2, and set the door status for the target event.
Linked Alarm Output
Enable Linked Alarm Output, check Alarm Output 1 or Alarm Output 2, and set the alarm
output status for the target event.
Linked Audio Prompt
DS-K3B961TX Series Swing Barrier User Manual
57
Summary of Contents for DS-K3B961TX Series
