DS-KH9510-WTE1 Video Intercom Indoor Station User Manual
UM DS-KH9510-WTE1 Video Intercom 031821NA
4
Caution
•
Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism
radiation. Avoid the equipment installation on a vibrating surface or places subject to shock (ignoring
this can cause equipment damage).
•
Do not place device in extremely hot (refer to the specification of the device for the detailed operating
temperature), cold, dusty, or damp locations, and do not expose it to high electromagnetic radiation.
•
The device cover for indoor use shall be kept from rain and moisture.
•
Exposing the equipment to direct sunlight, low ventilation, or heat source such as heater or radiator is
forbidden (ignoring this can cause fire danger).
•
Do not aim the device at the sun or extra bright places. Blooming or smearing may occur otherwise
(which is not a malfunction, however), and affect the sensor endurance at the same time.
•
Use the provided glove when opening the device cover; avoid direct contact with the device cover,
because the acidic sweat of the fingers may erode the surface coating of the device cover.
•
Use a soft and dry cloth when cleaning inside and outside surfaces of the device cover, do not use
alkaline detergents.
•
Keep all packaging after unpacking them, for future use. In case any failure occurs, you need to return
the device to the factory in the original packaging. Transportation without the original packaging may
result in device damage and lead to additional costs.
•
Improper use or replacement of the battery may result in explosion hazard. Replace with the same or
equivalent type only. Dispose of used batteries according to the instructions provided by the battery
manufacturer.
•
Input voltage should meet both the SELV and the Limited Power Source according to 60950-1
standard.
•
The power supply must conform to LPS. The recommended adaptor models and manufacturers are
shown below. Use the attached adapter, and do not change the adaptor randomly.
Model
Current
Manufacturer
Standard
MSA-C1500IC12.0-18P- US
1.5 A
MOSO POWER SUPPLY TECHNOLOGY CO., LTD
PG
TS-A018-120015AD
1.5 A
SHENZHEN TRANSIN TECHNOLOGIES CO., LTD PG
•
Improper replacement of the battery with an incorrect type may defeat a safeguard (for example, in
case of some lithium battery types).
•
Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the battery, which
may result in an explosion.
•
Do not leave the battery in an extremely high temperature surrounding environment, which may result
in an explosion or leakage of flammable liquid or gas.
•
Do not subject the battery to extremely low air pressure, which may result in an explosion or the
leakage of flammable liquid or gas.