ECI-B64Z2 Quick Start Guide
QSG ECI-B64Z2 041018NA
4
8.
Adjust zoom and focus (refer to
2.3 Zoom and Focus Adjustment
).
9.
(Optional) Install the water-resistant jacket for network interface. Refer to
2.4 Installation
of Network Cable Water-Resistant Jacket (Optional)
for detailed installation
procedures.
2.3
Zoom and Focus Adjustment
2.3.1
Type I
Purpose:
Use the zoom lever and focus the lever to adjust zoom and focus levels. Follow the steps
below to adjust focus and zoom.
Steps:
1.
Remove the sun shield and front cover to expose the zoom and focus levers.
2.
View the camera image on the monitoring screen.
3.
Loosen the zoom lever and move the lever between T (Tele) and W (Wide), in order to
obtain the desired angle of view.
4.
Tighten the zoom lever.
5.
Loosen the focus lever, and move the lever between F (Far) and N (Near) to obtain the
optimum focus.
6.
Tighten the focus lever.
7.
Install the sun shield and the front cover back onto the camera.
D
C12
V I N
Zoom/Focus Lever
Zoom and Focus Adjustment
Figure 2-8
Note:
If the camera is equipped with a fixed lens, you don’t need to adjust the zoom and focus.
2.3.2
Type II
Cameras of this type are equipped with a motorized varifocal lens. You can adjust the zoom
and focus level on the PTZ control panel by visiting the camera via a Web browser or client
software.
For detailed steps, refer to the network camera user manual.