2
Installation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with your
power output to avoid the damage.
Make sure the wall is strong enough to withstand three
times the weight of the camera and the mount.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use self-
tapping screws to secure the camera.
If the product does not function properly, contact your
dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1
Installation of Type I Camera
2.1.1
Ceiling Mounting without Junction Box
Before you start:
Both wall mounting and ceiling mounting are suitable for
the bullet camera. Ceiling mounting will be taken as an
example in this section. And you can take steps of ceiling
mounting as a reference for wall mounting.
Steps:
1.
Paste the drill template (supplied) to the place where
you want to install the camera.
2.
Drill the screw holes and the cable hole (optional) in
the ceiling according to the drill template.
Figure 2-1
Drill Template
Note:
Drill the cable hole, when adopting ceiling outlet to
route the cable.
3.
Route the cables through the cable hole, or the side
opening.
4.
Fix the camera to the ceiling with supplied screws.
Figure 2-2
Fix the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
