OPERATING INSTRUCTION
1. Connect the plug to a 120V/60HZ outlet.
2. Press the switch on the unit with the”
●
”for 500W of heat. Press the”
●
●
”switch only and two heater panels
will activate producing 1000W of heat. Press the two switches together for 1500W of heat.
3. Turn off the heater, press both switches downward.
NOTE: THIS PORTABLE ELECTRIC HEATERS ARE DESIGNED FOR SPOT HEATING OR AS A
SUPPLEMENTARY HEAT SOURCE. THEY ARE NOT INTENDED TO BE THE MAIN SOURCE OF HEAT
DURING THE COLD MONTHS.
OVERHEAT PROTECTION SHUT–OFF
If an overheat temperature is reached, the heater will automatically shut off.
It can only resume operation after the user resets the unit. Before reset, please inspect and remove any
objects on or adjacent to the heater that may cause high temperature.
RESET THE HEATER:
1. Turn the heater off.
2. Unplug the heater.
3. After 5-10 minutes, plug the unit in again and operate normally.
CAUTION:
You must always take care that there is sufficient distance for safety (at least 3’’)
between the heater and the wall or other objects.
PLEASE AVOID THE USE OF AN EXTENSION CORD, HOWEVER, IF YOU MUST USE AN EXTENSION
CORD,THE CORD SHOULD BE NO.14 AWG MINIMUM SIZE AND RATED NOT LESS THAN 1875 W.
