10
7EN160167 Rev. 8 • 2020
www.hillrom.com
Adjusting the loop straps
The tension of the vest around the chest is determined by which loop you attach to the sling bar. By test lifting using different
loops together with the shoulder straps, you can determine which position gives the right degree of tension.
If the vest slides up - try an inner loop or a smaller sized vest.
If the vest is too tight around the chest - try an outer loop or a larger sized vest.
For a slender person, you would need to use an inner loop and for a heavier person, you would need to use an outer loop if
both were using the same size of vest.
When loop straps are properly adjusted, the shoulder straps and loop straps are equally taut during lifting.
Testing loop strap adjustments
Stand behind the patient and hang the shoulder straps and
loop straps on your thumbs. Lift until the straps are fully sus-
pended. If properly adjusted, the shoulder straps and loop
straps will be equally taut.
Adjusting the leg supports
Generally, the leg supports are adjusted according to the
height of the patient. For a shorter person, attach the leg
supports’ inner loops to the sling bar. This usually enables a
more reclined sitting position.
Try different alternatives until you find the best one.
Helpful hint:
Instead of connecting the inner loop,
try knotting the leg support loops.
Gives an upright sitting
position. Suitable for
most patients.
Suitable for shorter
patients.
Loop Clips
This practical accessory is used to mark the loops that have
been tried out for a certain person.
It makes it easier for the caregivers to choose the right loop
to attach to the sling bar.
