Service Manual Viking™ M
mobile lift
• 3EN370401 Rev. 21
10
www.liko.com
l
www.hill-rom.com
2.3 Troubleshooting Viking™ M mobile lift, 2040035
The lift doesn’t work up/down with
Hand Control.
The base-width adjustment doesn’t
work (in/out) with the Hand Control.
The lift does not work up/down with
the operation panel.
The base-width adjustment doesn’t
work (in/out) with
the operation panel.
The charger doesn’t work.
The lift is stuck in the high position.
If you hear unusual sounds.
1. Check that the emergency stop button has not been pressed.
2. Check the battery capacity.
3. Check that the charger cable is not connected to an electric outlet.
4. Check that the hand control cable is correctly connected.
5. If the lift works via the operation panel, change the Hand Control.
6. If the problem persists, please contact Hill-Rom.
1. Check that the emergency stop button has not been pressed.
2. Check that the cables to the control box are connected correctly.
3. Check that the charger cable is not connected to an electric outlet.
4. Check the battery capacity.
5. If the problem persists, please contact Hill-Rom.
1. Check that the emergency stop button has not been pressed.
2. Check that the charger cables are connected correctly.
3. Make sure that the battery is properly attached.
4. If the problem persists, please contact Hill-Rom.
1. Check that the emergency stop button has not been pressed.
2. Check the battery capacity.
3. Check that the hand control cable is connected correctly.
4. Electrical emergency lowering, use the operation panel to lower the
patient onto a firm surface.
5. Use the mechanical emergency lowering device to lower the patient
onto a firm surface.
6. If the problem persists, please contact Hill-Rom.
Contact Hill-Rom.
