4.5 Leg Subassembly
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 10
TRANS
l
LIFT
TM
Resident Stand Assist Service Manual (man173)
4
4.5
Leg Subassembly
Tools required:
Socket head wrench
Removal
CAUTION:
Lay a sheet or other protective cloth on the floor before turning the unit
on its back. Failure to do so could result in equipment finish damage.
1. Lay a sheet or other protective cloth on the floor. Place the unit on its back.
2. Remove the base cover (refer to procedure 4.3).
3. Remove the tie rod assembly from the leg subassembly (A) (refer to
procedure 4.4) (see figure 4-6 on page 4-10).
Figure 4-6. Support Leg
4. Remove the elastic stop nut (B), flatwasher (C), and shoulder bolt (D)
securing the leg subassembly (A) to the back support subassembly (E).
5. Remove the leg subassembly (A) from the back support subassembly (E).
m173_013
