Getting Started
Chapter 2: Troubleshooting Procedures
TRANS
l
LIFT
TM
Resident Stand Assist Service Manual (man173)
Page 2 - 3
2
Getting Started
WARNING:
Only facility-authorized maintenance personnel should troubleshoot the
TRANS•LIFT
TM
Resident Stand Assist. Troubleshooting by
unauthorized personnel could result in personal injury or equipment
damage.
Begin each procedure in this chapter with step 1. Follow the sequence outlined
(each step assumes the previous step has been completed). In each step, the
normal operation of the product can be confirmed by answering Yes or No to
the statement. Your response will lead to another step in the procedure, a repair
analysis procedure (RAP), or a component replacement. If more than one
component is listed, replace them in the given order.
Start with Initial Actions to begin gathering information about the problem.
Perform the Function Checks to isolate or identify a problem and to verify the
repair after completing each corrective action (replacing or adjusting a part,
seating a connector, etc.).
Perform the Final Actions after the Function Checks to verify the repair.
If troubleshooting procedures do not isolate the problem, call Hill-Rom
Technical Support at (800) 445-3720 for assistance.
Initial Actions
Use Initial Actions to gather information from operators concerning problems
with the TRANS•LIFT
TM
Resident Stand Assist. Note symptoms or other
information concerning the problem that the operator describes. This
information helps identify the probable cause.
1. Someone who can explain the problem is available.
Yes
No
↓
→
Go to “Function Checks” on page 2-4.
2. Ask that person to demonstrate or explain the problem. The problem can be
duplicated.
Yes
No
↓
→
