4.2 Rear Caster
Chapter 4: Removal, Replacement, and Adjustment Procedures
TRANS
l
LIFT
TM
Resident Stand Assist Service Manual (man173)
Page 4 - 5
4
4.2
Rear Caster
Tools required:
Socket head wrench
Removal
CAUTION:
Lay a sheet or other protective cloth on the floor before turning the unit
on its side. Failure to do so could result in equipment finish damage.
1. Lay a sheet or other protective cloth on the floor. Place the unit on the side
opposite from the caster being replaced.
2. Remove the elastic stop nut (A) and carriage bolt (B) securing the rear
caster (C) to the back support subassembly (D) (see figure 4-2 on page
4-5).
Figure 4-2. Rear Caster
3. Remove the rear caster (C) from the back support subassembly (D).
m173_011