4.3 Base Cover
Chapter 4: Removal, Replacement, and Adjustment Procedures
TRANS
l
LIFT
TM
Resident Stand Assist Service Manual (man173)
Page 4 - 7
4
4.3
Base Cover
Tools required:
Socket head wrench
Removal
1. Set the caster brakes.
2. Remove the two hex head bolts (A) and two flatwashers (B) securing the
base cover (C) to the back support subassembly (D) (see figure 4-3 on page
4-7).
Figure 4-3. Base Cover
3. Remove the base cover (C) from the back support subassembly (D).
Replacement
Perform the removal procedure in reverse order.
m173_015