Remove blue cap - screw anticlockwise
Slowly squeeze the Hill
A72
Silicone Oil through the exposed hole until the oil reaches the
limit
indicated on the reservoir
by the blue line
DO NOT MIX CRANK OIL AND SILICONE OIL
Replace blue cap until finger tight
3. Power connection and Operating Instructions
Connect filling probe to hose, ensure spanner tight
or use Quick Release Coupling fitted
2. Silicone Lubricant Level
Fill the lubricant reservoir
using the following:
5
Connect filling probe to
bottle
or gun
and
ensure spanner tight
Ensure bleed screw is closed (finger tight)
CAUTION:
If using a quick release release coupling,
always check and make sure the collar on the female
quick disconnect is in
the forward position and secure
on the male fitting you are connecting it to. It is
recommended
that you check the connection by attempting
to pull the female and male ends apart while the collar
on the fitting is in the forward position
before pressurising
.
Insert power cable into pump
Please avoid using any electrical extension leads if possible. However, if you
must use
a 3rd
party extension lead, this must be
as short as possible and must
be
rated to a minimum of
110v/16A or 230v/13A depending on your local power supply. If unsure, please determine
what your local power supply is
before operating the compressor.
