5
GENERAL ASSEMBLY DETAILS
ALL DIMENSIONS ARE EQUAL ABOUT CL UNLESS
1.
OTHERWISE STATED.
DIMENSIONS BOUNDED BY ARE CRITICAL FOR
2.
ASSEMBLY WITH OTHER COMPONENTS.
THE DIMENSIONS SHOWN ON THIS DRAWING PLUS
3.
THE 3D CAD DATA FULLY DEFINE THE FINISHED PART.
ALL COMPONENTS TO BE CLEAN AND FREE FROM
4.
SHARP EDGES, BURRS AND DEFECTS.
IF IN DOUBT ASK
5.
GENERAL TOLERANCES:
Unless Otherwise Stated:
0 Dec. place 0.5mm
1 Dec. place 0.25mm
2 Dec. place 0.10mm
Holes: +0.25mm -0mm
Angles: 0.25
FIG. 4
6
D
C
B
A
E
F
G
H
E
A
B
C
D
F
5
4
3
2
1
7
8
9
10
11
12
1
2
3
4
5
6
7
8
G
9
10
11
12
H
Project:
X. Xxxxxxxx
DO NOT SCALE DRAWING.
DIMENSIONS IN MILLIMETRES.
Third Angle
Projection.
Approved:
Date:
Date:
XX.XX.XX
Checked:
22.09.10
P. Stevens
Date:
Drawn:
Issued / Received
1
Issue:
Sheet 1 of 1
TM
Colour:
Material:
Finish:
Description
A2
Drawing Number
Estimated Mass:
Project Number
Sheet
size
FD88012
EVERYDAY ROTARY 47
REFER TO INDIVIDUAL COMPONENTS
10259 (grams)
REFER TO DRAWING SPECIFICATION
REFER TO COLOUR TABLE
SCALE:1:2
Volume
3014089 (mm³)
MID MARKET ROTARY
D423
Hills Industries Limited
ABN 35 007 573 417
Home & Hardware Products
Unit H, 5 Butler Boulevard
Burbridge Business Park
Adelaide Airport
South Australia 5950
Copyright
©
2010
Revision 4 - 09.02.10 - DHN
Additives:
Fig. 4
Operation
Latch
Latch detail
Lower cross
Press to
release
Step 4
Operating the Hoist
4.1
To adjust the height of your Rotary Hoist,
wind the handle and head assembly
down and then fit one or more of the
plastic spacers in the ground socket.
The suggested operating height is the
user’s head 25mm (1") (
Fig. 4
).
Note:
The height adjusting winding
mechanism has an automatic device to
disengage the handle at the maximum
and minimum heights.
A slight ‘clicking’ noise will be heard
when this system is operating.
4.2 To Open:
Undo the line tie-off cord.
(
Refer to step 6
). Make sure the lines
are tangle free. Push the lower cross and
arms up until the latch engages.
4.3 To Fold:
Press the latch to release the
lower cross. Place your hands on the
arms and pull downwards.
4.4
Wrap and fasten the line tie-off cord
around the hoist to prevent lines from
becoming tangled.
4.5 To Remove from the ground socket:
Unlock the locking collar by rotating
anti-clockwise. Lift the Rotary Hoist
from the ground socket and store in a
suitable place. Insert the cover into the
top of the ground socket.
Cover
User
head
height
+25mm
(1")
Ground level
Locking collar
Spacers
Ground socket
