Hills Home Hub Owner’s Manual
Page 21 of 37
Patching Phone and Data Outlets
You may have a single RJ-45 socket on a wall plate that is set up for Phone, and you want
to connect a computer instead (or vice-versa and change a Data socket into a Phone
socket).
The Hills Home Hub allows you to easily change phone and data sockets:
Phone 3
Data 2
Requirements
Your home must be set up for patching services, which requires the following in your Hills
Home Hub enclosure:
•
HES-108 Ethernet Hub
•
HDM-808 Data / Patch Panel
•
HTM-408S
RJ
Telephone Module (if only a HTM-408S is present you will not be
able to patch phone services, contact your installer for assistance)
•
and some patch cables (which should already be connected)
Phone 3
HES-108
HDM-808
HTM-408SRJ
Phone 3
Patch Cable
RJ-45 Socket for
Phone
Note
You are free to increase the number of telephone sockets in your house up to the
maximum number supported by your installation (depends on the number of modules and
wall plates installed).
But make sure you do not
connect
more equipment (e.g. phones) to wall sockets than
your home supports. Otherwise your equipment may stop working. This is determined by
your REN. Read the Technical Terms section titled “REN and RN – Ringer Equivalence
Number” for more information.
Connecting Phone & Data - Patching Phone and Data Outlets