Page 8 of 37
Hills Home Hub Owner’s Manual
Security System Warning
Note that there are some parts of the Hills Home Hub
you should not touch
including
your security system wiring. The intelligent Hills Security System can detect tampering
attempts to its security wiring and may notify your monitoring company of this if you have a
monitored security system.
This may incur call out fees for a patrol guard to visit your
premises to check that everything is OK. Further fees may apply to rectify any
problems.
If you have a “back to base monitoring” service (which usually incurs monthly fees), please
make sure to notify your monitoring company of the time
and duration
that you are going
to open the Hills Home Hub enclosure. Check with them if it will be OK to open the lid of
your Hills Home Hub and ensure you have a valid PIN to disarm the security system
should the alarm go off.
When you are working on equipment contained inside your Hills Home Hub, take care not
to touch or disconnect any of the security wiring. It also uses power, so make sure to turn
the power back on if you have turned it off.
Once you have finished working on the Hills Home Hub, firmly close and lock the lid. Then
let your monitoring company know you have finished. Failure to do these may also trigger
a false alarm or disable tamper monitoring on your enclosure!
Some sample locations of the Hills Security System in your enclosure:
400 Series Hub
600 Series Hub
1000 Series Hub
UHills Home Hub - Security System Warning