Date: 05-23-07
Page 2 of 3
K
L
R
P
P
K
L
M
F
E
D
D
E
F
A
G
G
A
A
STEP 2
Attach each Cross Brace (P) to
the inside of each back post on
each Full End Panel (K) & Open
End Panel (L) using 1 Allen Bolt
(D), 1 Spring Washer (E) & 1 Flat
Washer (F) per each side. Once
in place, attach each Cross Brace
(P) to the bottom side of the
Support Brace (R) also using 1
Allen Bolt (D), 1 Spring Washer
(E) & 1 Flat Washer (F) per each
side. Do not fully tighten bolts.
STEP 3
O n c e i n p l a c e ,
carefully attach the
Top Support Frame
(M) to the inside of
each Full End Panel
(K) & Open End
P a n e l ( L ) b y
centering in place
and inserting the
metal tabs into the
open metal slot on
the inside of each
post. Make sure each
side is in proper place
before securing with
1 Square Lock Nut
(G) from the outside
of the Support Frame
and 1 Allen Bolt (A)
from the outside of
each post on the end
panels. Do not fully
tighten bolts.
