23
Chapter 1 Introduction
|
Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Table 1-27: SFP Copper Module Attributes
Attribute
Description
Connector
RJ-45
Port Standard
Auto-MDI/MDIX (crossover cable and straight-
through cable autosensing)
Maximum Transmission
Distance
100m
Negotiation Mode
10/100/1000Mbps autosensing (some only supports
1000Mbps)
Full / half-duplex
Cautions:
The SFP electric modules of all platforms only support 1000Mbps.
Before switching between the optical and copper cable connection on
Combo ports, you need to first clear the rate and duplex mode
configurations in the current operating mode (copper or optical), and re-
configure the port after the switching.
SFP+ Port
Table 1-28: SFP+ Port Attributes
Attribute
Description
Connector
SFP+
Frame Format
Ethernet_II
Ethernet_SNAP
Negotiation
Mode
SFP+ optical module
10Gbps
If you choose to use SFP+ optical module in SFP+ port, you should use LC-Type
optical connector. Hillstone device supports four types of 10G Base-FX SFP+ optical
modules. All optical modules are hot-swappable.
Caution:
To avoid dust falling into the SFP+ socket, you should place a rubber dust
cap (provided in the accessory box) over the SFP+ port.
