33
Chapter 2 Installation Preparations
|
Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Use electromagnetic shielding when necessary.
Grounding Requirements
To use the device more safely:
Ensure that the grounding screw of the chassis is well grounded via the
grounding wire.
Ensure that the grounding pin of the power plug is well grounded.
Workbench Requirements
Before the installation, ensure your workbench is properly prepared as follows:
Make sure that you provide adequate space near the intake and exhaust vents
of the device for heat dissipation.
Make sure the rack is equipped with a good ventilation system.
Make sure the rack is strong enough to support the weight of a fully equipped
device.
Make sure the rack is well grounded.
Other Safety Recommendations
The directions below are also recommended for you to follow:
Keep the device far away from moist areas and heat sources.
Wear an ESD wrist strap correctly when handling the device.
Be careful with laser emission. Do not directly stare into apertures of fiber-
optic connectors that emit laser radiation.
Use uninterrupted power supply (UPS).
Keep the device in locations where children are not likely to be present.
There may be risk of fire or explosion if the button cell is replaced by an
incorrect type
Unpacking
Verify the parts received according to your purchasing contract and packing list to
ensure that you have received all the items necessary. If you have any problem,
please contact your sales representative.
Installation Devices/Tools/Cables
A Hillstone device is shipped with a power cable and a console cable, and you
should have the following items before the installation:
