52
Chapter 5 Hardware Maintenance and Replacement
|
Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Figure 5-6: Installing the Blank Panel
Take the following steps to remove the hard disk module:
1.
Make sure the device is not powered and you have worn antistatic gloves.
2.
The hard disk module is at the bottom of the device, you should turn over
the device to make sure the hard disk module is visible. In order to avoid
the top of the device being scratched, make sure the workbench is stable
and clean.
3.
Use a screwdriver to remove the blank panel from the hard disk slot.
4.
Use a screwdriver to remove the hard disk module from the hard disk slot,
and put the removed module and screw into an antistatic bag or on a flat
antistatic table.
Note: If you do not want to install a new module, apply a blank plate over the
slot to avoid dust falling into the chassis.
