41
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Figure 3-8: Connecting an AC Power Cable
Note: If a product does not have a power switch, you can skip Step2 and Step4.
Connecting a DC Power Cable
To power the device with DC power source, use DC power cables to connect the
device and the external DC power source.
Warning: Before performing the procedure, ensure that the cable is not connected
with any power source and make sure the cables will not be powered on during the
process.
To connect the DC power cable to the device, take the following steps:
1.
Ensure that the power source voltage is in accordance with required voltage
specified in System Parameters.
2.
Switch off the power source.
3.
If the terminal on the power supply module has a plastic cover, remove the
cover and keep it.
4.
Connect the grounding screw (labeled with “
”) to the ground contact point
using a grounding wire.
5.
Use DC cables to connect the “+” terminal of the device to the “+” terminal
of the power source, and “-” terminal to the “-” terminal of the source.
6.
Verify the connection is correct and fasten the cables using a screwdriver.
7.
Recover the plastic cover(s) to the original terminal(s).
8.
To connect more DC power cables, repeat Step3 to Step7.
9.
Switch on the power supply module.
10.
Switch on the power source and check if the PWR LED is on. A shining LED
indicates correct connection.
