42
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Figure 3-9: Connecting a DC Power Cable
Connecting a Power Adapter
To provide the power supply, connect the power adapter of the devices with the
external AC power supply as follows:
1.
Insert the DC output plug of the power adapter into the AC power interface at
the back panel of the device.
2.
Connect the power adapter to the external AC power supply.
Installing an Antenna
To use the WLAN, 4G function of the device, you must install the WLAN, 4G
antenna. You can adjust the angle of the WLAN or 4G antenna by rotating it. The
antennas are shown as below:
Figure 3-10: 3 WLAN and 4G Antennas
To install antennas for SG-6000-E1100 (WLAN version), SG-6000-E1100 (4G
version) or SG-6000-E1100 (WLAN+4G version), take the following steps:
