50
Chapter 5 Hardware Maintenance and Replacement
|
Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Installing and Removing the Hard Disk Module
SG-6000-E6368, SG-6000-E6168, SG-6000-E5568, SG-6000-E5268, SG-6000-
E5168, SG-6000-E3968, SG-6000-E3668, and SG-6000-E2868 are designed with
the hard disk module.
Take the following steps to install the hard disk module:
1.
Make sure the device is not powered and you have worn antistatic gloves.
2.
The hard disk module is at the bottom of the device, so you should turn over
the device to make sure the hard disk module is visible. In order to avoid
the top of the device being scratched, make sure the workbench is stable
and clean.
3.
Use a screwdriver to remove the blank panel from the hard disk slot you
want to insert.
Figure 5-3: Removing the Blank Panel
4.
Place the hard disk module into the slot.
