14
Chapter 1 Introduction
|
Hillstone
Hillstone SG-6000 X-Series Expansion Modules Reference Guide
connection error.
Off
The expansion module is working abnormally or is
not in the slot.
LNK
Green/Always on
The link between this port and its peer device is in
normal status.
Off
The link between this port and its peer device has
failed.
ACT
Yellow/Blinking
The port is sending or receiving data.
Off
No data is transmitted on this port.
INLINE
Green/Always on
The bypass module is working in the inline mode.
Orange/Always on
The bypass module is working in the bypass mode.
Off
The bypass module is not powered, which means it is
in the bypass mode.
PWR
Green/Always on
The power of expansion module is running normally.
Orange/Always on
The power of expansion module is running
abnormally.
Red/Always on
Power failure so the expansion module is down.
Off
The expansion module is powered off.
STA
Green/Always on
The expansion module is booting.
Green/Blinking
The expansion module is running normally.
Red/Always on
The expansion module has failed to boot or has an
error.
Notes:
Different module has different LED indicator. Please refer to the actual
product.
SWAP Pinhole
SCM, SSM, QSM and IOM support hot-swapping and hot-plugging. When you want to
replace a module without causing major interruption to system, you need to use the
SWAP pinhole which is in the front panel of the module of SG-6000-X7180.
To remove an expansion module without interrupting the system, take the following
steps:
1.
Use a pin to insert into the SWAP pinhole.
2.
Observe the SYS LED indicator on the panel. When the LED turns steadily
orange, it means the module is ready to be removed.
3.
When the system powers off the expansion module, pull out the module.
Notes:
The system does not support hot-plugging using SWAP pinhole so far.
Ports
This section describes the attributes of the ports on IOM.
