15
Chapter 1 Introduction
|
Hillstone
Hillstone SG-6000 X-Series Expansion Modules Reference Guide
SFP Port
IOM-16SFP-100 has 16 SFP ports. The following table describes the attributes of SFP
port.
Table 1-9: SFP Port
Attribute
Description
Connector
SFP
Frame Format
Ethernet_II
Ethernet_SNAP
Negotiation Mode
SFP optical module
1000Mbps
Caution
: To avoid dust falling into the SFP socket, you should place a rubber dust cap
(originally in the accessory box) over the SFP port.
Hillstone SG-6000-X series supports SFP optical module, but not SFP copper module.
If you want the device to connect to an Ethernet copper cable, you need to use a
copper SFP transceiver (Copper SFP transceiver of type FCLF-8520-3 from Finisar is
recommended).
If SFP optical module is applied to SFP port, you should use cable with LC-type optical
connector. The following types of SFP optical module are available. All optical
modules are hot-swappable.
Table 1-10: SFP Optical Module Attributes
Attribute
Description
Short-haul
Multimode
Optical
Module
(850nm)
Medium-
haul
single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1550nm)
Ultra-long
Haul Single-
mode
Optical
Module
(1550nm)
Connector
LC
Fiber Type
62.5/125μm
Multi-mode
fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-mode
fiber
Maximum
Transmission
Distance
0.55km
10km
40km
40km
70km
Central
Wavelength
850nm
1310nm
1310nm
1550nm
1550nm
XFP Port
IOM-4XFP-100 provides four XFP ports to connect to XFP optical modules.