30
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
7.
Verify the installation. Make sure every two screw pairs are in the same
horizontal line and the device is stably placed on the plate.
Installing the Device without a Lift
If you do not use a lift to install the device, you should remove all parts that can be
removed from the chassis and re-install them when the chassis is properly positioned.
When all hardware components are removed, the chassis weighs 30.8kg, and it
requires at least two people to install the appliance.
To install the devicewithout a lift, take the following steps:
1.
Wear an ESD strap and connect the other end of the strap to the ESD point on
the chassis. See
2.
Make sure the device is not powered and it will not be powered during the
removing process.
3.
Dismantle all the removable components, including power modules, all
expansion modules (SSM, SCM, QSM and IOM), blank plates and fan trays.
4.
Label all the removed parts so that you can reinstall them in the correct location.
5.
Move the chassis in front of the rack.
6.
With one person standing on each side, lift the chassis onto the tray of the rack
or cabinet.
7.
Use the screws to attach the left and right brackets to the rack.
8.
Verify the alignment of the screws. Make sure every two screw pairs are in the
same horizontal line.
9.
Reinstall all removed hardware components back to the proper locations.
See
, and
Note: Before powering on the device, all empty slots should be covered with blank
plates.
Installing Expansion Modules
This section describes how to install the expansion modules which are not pre-
installed at the factory. The device requires at least one SCM, one SSM and one IOM.
Additional expansion modules are added according to your needs.
This part includes the following sections:
♦
Tools required
♦
Installing an SCM
♦
Installing an SSM
