34
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
Figure 3-8: Installing an IOM (IOM-16SFP)
6.
Tighten the screws on the IOM with a Philips screwdriver.
7.
To install more IOMs, repeat Step 2 to 6.
Installing a Bypass Module
Hillstone SG-6000-X7180 supports two types of bypass module: single-mode bypass
module (IOM-2SM-BE) and multi-mode bypass module (IOM-2MM-BE). The bypass
module is installed in Slot1 to Slot10.
To install a bypass module, take the following steps:
1.
Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
2.
Take the bypass module out of its antistatic bag.
3.
Identify the slot of bypass module.
4.
If the slot is covered with a blank plate, loose its screws with a Philips
screwdriver and slide the plate out of the slot.
5.
Position the bypass module so that its front side faces you, and slide it into the
slot until you feel resistant, as shown in Figure 3-8.
