35
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
Figure 3-9: Installing a Bypass Module
6.
Tighten the screws on the IOM with a Philips screwdriver.
Installing a Power Module
This part describes how to install power modules. Both AC and DC power modules are
supported. A device requires at least two power modules and supports up to four
power modules. If each slot of device is installed with expansion module, please
install at least 3 AC (or DC) power modules. When there are four power modules
installed in the device, two of them are working normally to supply power and the
other two are for redundancy. If you want to install the SSM-200, QSM-200 or IOM-
-200 module to the device, please install at least 3 AC (or DC) power
modules.
This part includes the following sections:
♦
Tools required
♦
Installing an AC power module
♦
Installing a DC power module
Tools Required
To install a power module, you need the tools:
♦
Phillips screwdriver
♦
ESD wrist strap
Installing an AC Power Module
To install an AC power module, take the following steps:
1.
Make sure the power module is not connected to any power source and there is
no chance it will be powered during the process.
