48
Chapter 5 Hardware Maintenance and Replacement
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
Figure 5-1: Replacing an SCM
4.
Put the removed module into an antistatic bag or on a flat antistatic table.
5.
Install a replacement module (see
Note: If you do not want to install a new module, apply a blank plate over the slot to
avoid dust falling into the chassis.
Replacing an SSM
The following section takes SSM-20 as an example to describe how to replace an SSM.
To replace an SSM, take the following steps:
1.
Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
2.
Use a Phillips screwdriver to loosen SCM screws until they pop out.
3.
Hold the screws and pull the SSM straight out of the chassis, as shown in Figure
5-2.
Figure 5-2: Replacing an SSM (SSM-20)
