Packing List:
C3XP Unit
10 Gallon water reservoir (integral)
Spray gun w/ 2 settings
17 ft. discharge hose (installed)
12-volt battery
Battery charger
Telescoping handle
Instruction manual
Removable Cleaning Caddy 18’’ floor squeegee
Pivot arm
Pivot arm lock bar w/locking nut
Utility Bag
Initial Setup:
The battery is shipped installed and charged, but not connected to the pump. To connect the battery,
remove the back cover by removing the four screws with a phillips head screwdriver. Connect
terminal on the black wire to the black terminal on the battery. If the pump begins to run, turn the unit off
with the switch on the front. Put the back cover back onto the unit by replacing the four screws with a
phillips head screwdriver.
Attach the spray gun to the discharge hose.
Attach plastic pivot arm to front of machine, install pivot arm lock bar through the pivot arm and the
C3XP machine, attach and tighten locking nut.
(see picture on front of manual for reference)
Remove utility bag from plastic and install onto pivot arm with attached straps. Install utility bag with
zippers facing away from machine.
Remove the black cap from the water fill port (it rotates COUNTER CLOCK WISE to open). Fill the
tank to line (10.1 gallons) with cool clear tap water.
To connect the chemicals, remove the shipping cap, slide bottle into machine with the bottle opening
to the outside of the machine and attach the chemical feed line to the bottle by screwing the cap on
the line onto the bottle.
C3XP Owner's Manual
06/10/2011
1 of 6
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com