Initial Priming:
Set the spray gun to the low pressure setting
(see attached spray gun instructions).
Set the chemical selector to the desired product.
(see diagram at bottom of page)
[IN ORDER FOR
THE MACHINE TO INITIALLY PRIME CORRECTLY, YOU MUST PRIME WITH Cleaning
Companion PRODUCT IN USE]
Turn the switch on. The power switch is lighted when it is in the on position. The pump should run for
a short time then stop. (
There is a pressure switch in the pump that will stop the pump when the
discharge pressure reaches the set point
).
Direct the spray nozzle into a drain or other container and pull the trigger.
Run until a steady spray pattern is established.
Release the trigger. The pump should stop almost immediately. If it does not, operate the unit longer
as it is not fully primed.
Turn the selector to the other products and repeat.
Normal Operation:
The power switch is lighted when it is in the on position.
The pump will run when the trigger on the spray gun is pulled and stop when it is released.
The C3 is designed to use a low pressure setting for applying the cleaning/disinfecting
solution and high pressure setting for clear water rinsing. The new C3 rollover valve achieves
the low pressure setting by sending water through 2 spray tips and achieves the high
pressure setting by only utilizing the one high pressure tip.
When finished using the C3 machine, make sure the spray gun is left in the high pressure
(rinse) position to minimize dripping.
Detailed instructions for spray gun operation are contained at the end of this manual.
The pump will run for approximately 3 hours on a fully charged battery. The charger cannot be used
to run a C3 that has a fully discharged battery.
To select which chemical you would like to use, point selector switch to desired chemical using arrow
on selector switch. (See Diagram Below)
To select the rinse mode, place selector switch arrow to the position that is straight up from the
chemicals. (See Diagram Below)
C3XP Owner's Manual
06/10/2011
2 of 6
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
