DISPOSAL
To dispose of the machine, take it to a demolition centre or an
authorised collection centre.
Before scrapping the machine, it is necessary to remove
and separate out the following materials, then send them
to the appropriate collection centres in accordance with the
environmental hygiene regulations currently in force:
• Brushes
• Felt
• Electric and electronic parts*
• Batteries
• Plastic parts (tanks and handlebars)
• Metal parts (levers and frame)
(*) In particular, contact your distributor when scrapping electric
and electronic parts.
9. Grip the back of the seat (7) and turn the seat support plate to its maintenance position (
Fig.7
).
ATTENTION
: to prevent the seat from rotating, insert the retainer (8) into the slot (9) (
Fig.8
).
10. Disconnect the battery connector from the machine's main system connector (
Fig.9
).
11. Grip the back of the seat (7) and turn the seat support plate to the working position.
N.B.
: before rotating the seat support plate, remove the retainer (8).
ATTENTION
: these operations must be carried out using protective gloves to avoid any possible
contact with the edges or tips of metal objects.
12. Go to the right side of the machine.
13. Using the right equipment, not supplied with the machine, loosen the counter nut (10) (
Fig.10
).
14. Using the right equipment, not supplied with the machine, loosen the adjusting screw (11) (
Fig.11
),
until the bristles of the brush are squashed on the ground by about two centimetres.
15.
As soon as you have finished, tighten the counter nut (10) and move on to the left side brush.
8
8
9
7
7
6
1
OFF
11
11
9
10
10
36
