6.2
Adjustments
6.2.1
T20SC PRO
The scrub deck is tilted in the transverse
direction and should be adjusted longi-
tudinally inclined to the machine so that
the brushes have a distance of about
1
5
inch from the floor, larger on the front
than on the rear side. This allows the
brush to evenly lean to the ground and
perform its function properly.
Requirements:
mounted brush, switched
off machine.
Procedure:
• Hook the brushes to the scrub deck.
• Loosen the brushdeck fixing screw
to the left arm
(see fig.
.
• Place on the front of the brush, be-
tween the brush and the floor a
spacer of about
1
5
inch thick
(see fig.
.
• Lower the brush deck to the ground
and tighten the fixing screw of the
left arm.
• Tighten the fixing screw of the right
upper arm until the spring is com-
pressed 0,31in.
•
(50BT Only)
Adjust the brush in-
clination using the front adjustment
knob
(see fig.
.
6.2.2
T20SC ORBITAL PRO
Procedure:
• Hook the Pad and lower the scrub
deck.
• Loosen the brushdeck fixing screw
to the right upper arm
(see fig.
.
• Move the machine so that the scrub
deck fits the floor.
6.2.1-1
6.2.1-2
6.2.1-3
6.2.1-4
• Tighten the screw to fix the flatness
adjustment of the scrub deck.
6.2.2-5
50
Summary of Contents for TRIDENT T20SC PRO
Page 1: ...SERVICE MANUAL TRIDENT T20SC PRO Version AB Date November 7 2018 Document Number 10077483...
Page 4: ...Part I Product Introduction 4...
Page 8: ...Part II Anomalies Resolution Guide 8...
Page 28: ...Part III Machine Description 28...
