Hardware Installation and Uninstalling
60/145
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM36EN | Revision 36 | English | 2012-10 | Released | Public
© Hilscher, 2008-2012
6.3.2
Fix Front Plate Sticker at CIFX 70E-RE, CIFX 100EH-RE\CUBE
Note:
Your PC card CIFX 70E-RE or CIFX 100EH-RE\CUBE set contains a set of front
plate stickers (9 different stickers, each 2 parts). Depending from the loaded firmware the
label on each sticker indicates for the respective system the following
LED names
:
(1) of the
system and communication status LEDs
(
partial sticker above
)
(2) of the
RJ45 Ethernet female connector LEDs
(
partial sticker below
).
Further information to this question you find also in chapter
LED Descriptions
beginning
from page 66.
Electrostatically sensitive Devices
¾
To prevent damage to the PC and the PC Card cifX, make sure, that the
PC card cifX is grounded via the endplate and the PC and make sure,
that you are discharged when you install/uninstall the PC Card cifX.
¾
Use the two part sticker according to the device and firmware and glue
it on the front of the PC card CIFX 70E-RE or CIFX 100EH-RE\CUBE.
Front CIFX 100EH-RE\CUBE
Front CIFX 70E-RE
How to
1.
Glue the "partial sticker above" with the
system specific
names of the system
and communication status LEDs
above
1
of the LEDs COM1, COM0
and SYS on the front plate.
2.
Glue the "partial sticker below " with
the system specific
names of the
RJ45 Ethernet female connector
LEDs
below
2
of the RJ45 on the front
plate.
Table 35: Fix Front Plate Sticker at the CIFX 70E-RE or CIFX 100EH-RE\CUBE
