Getting Started
33/145
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM36EN | Revision 36 | English | 2012-10 | Released | Public
© Hilscher, 2008-2012
#
Step
Description
For detailed
information see
manual / section
Page
8.3
Download
Configuration
- Download the configuration to the PC card
cifX (Master).
Master Device
9
Slave Diagnosis by
SYCON.net
(Slave und Master)
Diagnosis, I/O Data
Use the corresponding Slave or Master DTM
in the configuration software
SYCON.net
.
9.1 Diagnostic
- Rightclick on the device symbol.
- Select context menu entry
Diagnosis
,
- then select
Diagnosis > General
or
Firmware Diagnosis
,
- or select
Diagnosis > Extended Diagnosis
.
9.2 I/O
Monitor
- Rightclick on device symbol.
- Select context menu entry
Diagnosis
,
- then
Tools > IO Monitor
.
-Check the input or output data.
See corresponding user
manual
10
OR
Slave Diagnosis
by
netX Configuration
Tool
(only Slave)
Diagnosis
10.1
Configuration Steps
cifX (Slave)
If SYCON.net was already used on the PC,
stop the ODMV3 service. Therefore, select
Service > Stop
from the context menu of the
ODMV3 system tray icon.
In the
netX Configuration Tool
:
- In the navigation area click on
Diagnostic
,
- click in the
Diagnostic
pane to
Start
, to
start the communication to the Master device
and to run the diagnosis.
- click on
Extended
, to run the extended
diagnosis.
See Operating
Instruction Manual netX
Configuration Tool for
cifX, comX and netJACK
Table 18: Steps for the Software and Hardware Installation, the Configuration and for the
Diagnosis of a PC Card cifX (Master and Slave)
4.2
Note on Exchange Service (Replacement Case)
For the exchange service (replacement case) of a PC card cifX (Master and
Slave) obey to the following note.
Important!
For the replacement card cifX
with
Rotary Switch Slot
Number (Card ID)
set the same
Slot Number (Card ID)
as at the
previous PC Card cifX (see section
Rotary Switch for Slot Number (Card
ID)
on page 91).
For PC Cards cifX
without
Rotary Switch Slot Number (Card ID)
in
terms of a device exchange service (replacement case) you must
manually download the same firmware and configuration into the
replacement card cifX, as into the preceding cifX.
4.3
Notes for the Configuration of the Master Device
To configure the Master, a device description file is required. Please note
the following notes for the configuration of the Master Device:
System
Note
EtherCAT Slave
To configure the Master, an XML file (device description file) is required. The settings in the
used Master must comply with the settings in the Slave to establish communication. Important
parameters are: Vendor ID, Product Code, Serial Number, Revision Number, Output and Input
Data Bytes.
