Hardware Installation and Uninstalling
58/154
PC Cards cifX PC/104 | Installation, Operation and Hardware Description
DOC120206UM42EN | Revision 42 | English | 2014-12 | Released | Public
© Hilscher, 2008-2014
3. If you are using the interrupt mode, set up a free interrupt on the PC
card cifX PC/104 (
Hardware
).
For polling operation mode interrupt jumpers are not required.
Note:
The default setting is address D0000 and no interrupt (
Basis
Configuration 0
). To change the address select
Basis Configuration 1
.
The interrupt and the address can be changed under
Basis
Configuration 2
.
Note:
On some PCs it is not possible to find a free ISA memory area
between C0000–FBFFF or a free ISA interrupt in the Device Manager.
This is Windows
®
(*) ACPI (Advanced Configuration and Power Manage-
ment Interface) depending. Please check at first if your PC is ACPI
compatible and you are using the latest BIOS version for your mainboard.
Are there still problems to find available ISA resources, you can try to run
Windows
®
(*) in "Standard PC" mode (ACPI disabled). Therefore the ACPI-
HAL of Windows
®
(*) must be replaced with the STANDARD-PC-HAL or
Windows
®
(*) must be installed new. Please contact Microsoft how to
change the Windows
®
(*) XP-HAL, because this can make your installation
unusable.
(*) Windows
®
XP
4. Reserve
Memory Range / Interrupt
at the
operating system
.
Reserve for the PC cards cifX PC/104 the memory range and if
necessary one interrupt at the operating system.
For further information refer to
User Manual Software Installation for the
PC Cards cifX
on the Communication Solutions DVD.
