Using SD memory card to copy configuration data into spare netTAP devices
50/63
Ê
On the SD memory card, a “Backup” folder is being created and the
data is copied from the netTAP into this folder. This can take a short
while (observe the clock symbol
in the footer of the dialog
window). After copying has been finished, you can inspect the data by
selecting a folder in the
SDMMC:\Backup
directory in the
Folder
window:
Figure 29: Memory Card Management after backup to SD memory card
Ø
Click
OK
to close the netTAP DTM.
Ø
Exit SYCON.net
6. Copy data from SD memory card into spare netTAP device.
Ø
Remove the SD memory card from the original netTAP device.
Ø
Insert the SD memory card into the spare device.
Ø
Connect spare device to voltage supply or briefly disconnect voltage
supply (in case the device had already been connected to voltage
supply).
ð
The spare netTAP device then loads the data from the SD memory card
into its own internal load memory. While loading, the SYS LED quickly
alternates between green and yellow for approximately eight seconds,
then shows steady yellow for approximately ten seconds, then is
switched off for a short while before it finally shows steady green light.
The device automatically starts the loaded firmware and the
configuration.
Ø
Remove the SD memory card from the netTAP device.
netTAP NT 151-CCIES-RE | CC-Link IE Field Slave to PROFINET IO-Device gateway
DOC180403UM01EN | Revision 1 | English | 2018-08 | Released | Public
© Hilscher 2018
