20
English
6.5.4 Cutting
▶
When cutting, apply moderate feed pressure and do not tilt the power tool or the cutting disc (when
working, hold at approx. 90° to the surface being cut).
Note
For best results when cutting profiles and square tube, start cutting at the smallest cross section.
6.5.5 Rough grinding
CAUTION
Risk of injury.
The abrasive cutting disc could shatter and flying fragments may cause injury.
▶
Never use abrasive cutting discs for grinding.
▶
Move the power tool to and fro while maintaining a 5° to 30° angle of attack and applying moderate
pressure.
◁
This will avoid overheating and discoloration of the workpiece and help ensure an even surface finish.
6.5.6 Switching off
▶
Release the on/off switch.
7 Care and maintenance
7.1 Care and maintenance
WARNING
Danger of electric shock!
Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶
Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock!
Improper repairs to electrical components may lead to serious injuries
including burns.
▶
Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• At regular intervals, check all visible parts and the controls for signs of damage and make sure that they
all function correctly.
• Do not operate the power tool if signs of damage are found or if parts malfunction. Have damage repaired
immediately by
Hilti
Service.
• After cleaning and maintenance, refit all guards or protective devices and check that they function
correctly.
7.2 Checks after care and maintenance work
▶
After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
8 Transport and storage
• Do not transport electric tools with accessory tools fitted.
• Always unplug the supply cord before storing an electric tool or appliance.
Printed: 27.07.2017 | Doc-Nr: PUB / 5238733 / 000 / 02
