16
English
6.3 Driving a nail
WARNING
Risk of injury by flying parts!
When driving a fastener, there is a risk of injury to
the body and eyes caused by splintered fragments of the workpiece and by flying
parts of the nail strip.
▶
Wear personal protective equipment and always wear protective glasses
and protective gloves.
Other persons in the vicinity must also wear eye
protection and a hard hat.
WARNING
Risk of injury!
Pressing the nosepiece of the fastening tool against a part of the
body may lead to serious injury due to inadvertent firing and release of a fastener.
▶
Never press the nosepiece of the tool against your hand or any other part
of the body.
1. Switch on the fastening tool. → page 15
2. Hold the fastening tool perpendicular to the working surface and press it against the
surface, pushing the fastener guide in as far as it will go.
3. Drive the nail by pressing the safety trigger.
4. Lift the fastening tool completely clear of the working surface after driving a fastener.
Note
The fastening tool switches itself off automatically if the fastener guide is pressed
against the working surface for longer than 6 seconds without a nail being driven.
The fastening tool can be switched on again by pressing the on/off button.
Note
The fastening tool switches itself off automatically if it is not used for 6 minutes.
6.4 Switching off Bluetooth
▶
Press the on/off button for at least 5 seconds until the LED shows blue twice.
◁
No further data transfer is possible.
Note
Bluetooth can be deactivated ff you are in a sensitive environment (e.g. a hospital)
where use of Bluetooth is prohibited.
Printed: 04.10.2017 | Doc-Nr: PUB / 5377202 / 000 / 01
Summary of Contents for BX 3-ME
Page 1: ...BX 3 ME English Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 2: ...Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 9: ...English 7 3 Description 3 1 Product overview Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 23: ...Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...